DIY MEDIACENTER INSTALL
It is time to install the stone or brick panels on the intended places on the wall. After the mud layer has cured sand the areas that need smoothing. The DT Media Center Build Using PcPartPicker we’ve put together an example build for a media center PC that comes in right around 500 and is appropriately equipped for streaming, playing blu-rays. When it has dried you can start laying the final coat on the drywall Move the hawk along the mud layer at an angle while applying pressure enough to take out the excess.Ĭure. Take off the surplus mud using a broad knife or the hawk. Take your hawk and trowel and lay a fine layer of mud all along each side of the corner bead. Farmhouse Style Media Cabinet: Give also a glam touch of farmhouse style to your modern living room by adding the farmhouse style media cabinet that is a piece of cake to make at home Build a cabinet with two glass paneled hinged doors and then magnify the look of it using accent wood molding Step-by-step instructions here buildsomething. Prepare the mud using the manufacturer’s instructions. Soldering Station ( a good quality station is recommended with at least 60w power) -Multi-meter (To check for current consumption and some continuity checks) -Tweezers (for component placement on the pcb) -Box cutter (To cut the housing to size.) -PCB drill with 0.5mm bit. They are fixed to the panels via drywall mud. This is a super simple project, and it’s made a fun difference in our living room for a nice change.
DIY MEDIACENTER HOW TO
Each corner bead should be cut precisely at the exact length of each drywall angle assy. We realized we’d never shared this easy diy media center with any of you and thought it was time to give a little how to in case you wanted it for your own home. When you have finished the arrangement and securing of the drywall panels, start placing the drywall corner beads which will connect the side angles of the drywall structure. Ensure all screw heads are slightly below the wall level. Each screw head shall slightly kink the metal, leaving a small pressure in the drywall panel. It is highly important to consider the thickness of the panel and the studs’ width when sizing the panels prior to cutting.Įach drywall panel is fixed to the metal structure with drywall screws. This will ensure that all parts fit well together – the panels to the frame structure and the panel-panel assy.
0 kommentar(er)
